Yanmar 1GM10 Dokumentacja Pobierz pdf (Strona 59)

PERIODIC MAINTENANCE

GM Series Operation Manual 53

12/05

PERIODIC MAINTENANCE

PROCEDURES

Perform the following maintenance after

the initial 50 hours of operation.

• Draining the Fuel Tank

• Draining the Fuel Filter / Water

Separator

• Changing the Engine Oil

• Replacing the Engine Oil Filter

Element

• Changing the Marine Gear Oil

• Checking and Adjusting the

Alternator V-Belt Tension

• Inspecting and Adjusting the

Intake / Exhaust Valve Clearances

• Inspecting and Adjusting the Throttle

and Shift Control Cables

• Adjusting the Propeller Shaft

Alignment

Draining the Fuel Tank

WARNING

When you are draining the fuel tank to

perform maintenance, put an approved

container under the opening to catch

the fuel. Never use a shop rag to catch

the fuel. Vapors from the rag are

flammable and explosive. Wipe up any

spills immediately. Wear eye protection.

The fuel system is under pressure and

fuel could spray out when you remove

any fuel system component.

1. Put a pan under the drain cock

(Figure 1, (2)) to catch the fuel.

Figure 1

Figure 1

1 – Sediment Bowl

2 – Drain Cock

3 – Fuel Line to Engine

Note: Optional fuel tank shown. Actual

equipment may differ.

2. Open the drain cock and drain water

and sediment. Close the drain cock

when the fuel is clean and free of water.

After Initial 50 Hours of

Operation

0004542

(3)

(1)

(2)

GM_OM.book 53 ページ２０１３年６月１０日　月曜日　午後２時２６分

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 93 94

Komentarze do niniejszej Instrukcji

Brak uwag