Yanmar 3HM Instrukcja Użytkownika Pobierz pdf (Strona 35)

V III. Storage

[8-1.] Storing

Whenever the engine will not be used for several months, use the following procedure to

properly store it.

This minimizes corrosion and deterioration.

1) Drain fuel completely from fuel tank, otherwise moisture from the fuel system will mix

with the fuel.

2) Wash the cooling system with clean tap water and drain out the cooling water from the

engine completely.

2-a)

Cylinder body

2-b) Exhaust manifold.

2-c)

Cooling water pump Remove the cover of the

cooling water pump and drain out the water inside of

the cooling water pump.

3) Apply an anti-rust oil to any parts which rust

easily.

4) Since the battery will automatically discharge

itself if left, disconnect when fully charged, wash the

exterior and store in a dry, well-aired place.

Re-charge once a month during storage.

1. Cooling water pump

5) Tape to seal air inlet, exhaust pipe, and fuel tank cap.

6) Clean the engine throughly. Touch up any painted surfaces that are scratched or chipped.

7) If boat must be stored outside, cover it with waterproof material.

[82.] Removing engine from storage

1) Wipe off anti-rust oil and check that the remote control system move smoothly.

2) Wiring the battery.

2-a) Rewire as shown in the wiring diagram.

2-b) Make sure wires are connected to the correct terminals.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 55 56

Brak uwag

Yanmar 3HM Instrukcja Użytkownika Strona 35