Yanmar 1GM10V Dokumentacja Pobierz pdf (Strona 71)

LONG-TERM STORAGE

Before performing any storage procedures

within this section, review the Safety section

on page 3.

If the engine will not be used for an extended

period of time, special measures should be

taken to protect the cooling system, fuel

system and combustion chamber from

corrosion and the exterior from rusting.

The engine can normally stand idle for up to

six months. If it remains unused for longer

than this, please contact your authorized

Yanmar Marine dealer or distributor.

PREPARE ENGINE FOR

LONG-TERM STORAGE

NOTICE: NEVER drain closed cooling

system for long-term storage.

Antifreeze must be used to avoid

freezing and damaging of components.

Antifreeze will prevent rusting during

long-term storage.

Note: If the engine is close to a periodic

maintenance interval, perform those

maintenance procedures before putting the

engine into long-term storage.

1. Wipe off any dust or oil from the outside

of the engine.

2. Drain any water from fuel filters.

3. Drain the fuel tank completely or fill the

tank to prevent condensation.

4. Drain the cooling system. (See Draining

the Cooling System on page 66.)

5. Grease the exposed areas and joints of

the remote control cables and the

bearings of the throttle and shift control

handle.

6. Seal the intake silencer, exhaust pipe,

etc., to prevent moisture or

contamination from entering engine.

7. Completely drain the bilge in the hull

bottom.

8. Waterproof the engine room to prevent

rain or seawater from entering.

9. Charge the battery once a month to

compensate for the battery’s self-

discharge.

GM Series Operation Manual 65

© 2007 Yanmar Marine International

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 91 92

Komentarze do niniejszej Instrukcji

Brak uwag