Yanmar BY series Dokumentacja Pobierz pdf (Strona 99)

PERIODIC MAINTENANCE

92 BY Series Operation Manual

Figure 7

7. Clean the filter bowl. Inspect the water

sensor probe (Figure 7, (1)) for

damage. Inspect the bowl seal

(Figure 7, (2)).

IMPORTANT

When replacing fuel filters, always

pre-fill them with fresh, clean fuel

to improve the system ability to be

bled.

8. Lubricate the seal at the top of the new

filter element and install (Figure 7, (3)).

9. Lubricate the filter bowl seal and install

the filter bowl. Turn clockwise by hand

to tighten.

10.Ensure drain plug (Figure 7, (4)) is

securely tightened.

11.Connect water sensor connector.

12.Open the fuel tank cock.

13.Connect the battery negative (-) cable.

14.Bleed air from the fuel system and

check for leaks. See Bleeding the Fuel

System on page 41.

Change the Engine Oil and

Replace Engine Oil Filter

Element

To change engine oil and replace the

engine oil filter element, see Change the

Engine Oil and Replace the Engine Oil

Filter on page 83.

Check or Replace the Seawater

Pump and Alternator Belts

Figure 8

1. Disconnect battery negative (-) cable

from the battery.

2. Remove belt guard.

(3)

(1)

(2)

(4)

0003650

CAUTION

Be careful not to get any oil on

the belt(s). Oil on the belt causes

slipping and stretching. Replace

the belt if it is damaged.

0000153enMarine

0003662

(

)

(

)

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 126 127

Komentarze do niniejszej Instrukcji

Brak uwag

Yanmar BY series Dokumentacja Strona 99

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Silnik Yanmar BY series